Prepare cleaning tools: brush, air blow, brush cleaner
2. Clean the dust box: Open the dust box, remove the filter, and clean it with a brush. If the filter is too dirty, soak it in detergent for a few minutes and then rinse it off with water. Do not force the filter to break!
3. Turn the Roomba over, press the bottom two yellow snaps and flip the bottom frame up and remove the brush and the glue one by one.
4. Remove the brush and the rubber brush and blow off the dust from the bottom yellow metal part with a gas blow.
5. Clean the inner wall: Use a brush to clean the dirt on the inner wall. If it is dirty, use a slightly moist rag. Be careful not to let the water touch the yellow metal parts, here is the dust detector!
6, clean the brush and rubber brush: brush using the iRobot Roomba standard hair cleaner to brush back and forth a few times hair is clean, then brush carefully with a brush , glue brush and brush can be washed, but should not dry Can put it back!
7. Clean the bearing: Pull out the yellow fasteners and bearings outwards and clean them carefully with a brush.
8. After cleaning, you can put the brush and rubber brush back.
9. After installing the brush and the rubber brush, press the bottom frame until you hear a click, indicating that the card is tight.
10, put on the dust box, you're done! The iRobot Roomba 560 can be put back into the job again.
Ejector Header Connector,Dual Row Ejector Header Connector,Single Row Ejector Header Connector,Gold Plated Ejector Header Connector
Shenzhen Jinyicheng Electronci Technology Co.,Ltd. , https://www.jycconnector.com