The creeping of the electric energy meter during operation is a phenomenon that is often seen and complicated, and the reasons are various. After careful investigation and analysis and testing on the spot, it is found that there are roughly five reasons for the potential of the electric energy meter:
(1) There is a slight load, such as the indicator light on the switchboard, the light switch, the line load doser, the voltage transformer, the transformer, the no-load operation of the welder, and the power factor is too low.
(2) The creep test failed. In general, the energy meter has a slight positive and negative error.
(3) The electric energy meter is not wired according to the positive phase sequence power supply.
(4) The three-phase voltage is seriously unbalanced.
(5) The current transformer is short-circuited or there is leakage, the insulation of the line is broken, and the current coil of the electric energy meter is burnt.
According to the above reasons, the following measures should be taken:
(1) If there is a slight load causing the sneak, check the cause of the sneak and explain to the user patiently and explain the situation.
(2) According to the electric energy meter verification procedure, the light load error is generally not excessive.
(3) Before installing the electric energy meter, the phase sequence must be measured at the site, and the power supply should be connected according to the positive phase sequence.
(4) Assist the user to adjust the power load, and achieve the relative balance of three-phase current and voltage.
(5) If the electric energy meter sneaks due to the fault, find the cause of the fault in time, check the electric energy meter, the transformer, modify the wiring, burn it with electric appliances, and so on.
We adopt the advanced technology imported from Europe, patented technology, specialized software to optimize the design for 11kV cast resin Dry Type Transformer. The core is made of cold-rolled grain-oriented silicon steel sheet which cut in step-lap by GEORG Germany TBA core cutting lines and laminated by the method of fifth-order step-by-step stacking technology, enabling the no-load performance of the core to improve greatly. The epoxy resin from American HUNTSMAN is adopted for the windings which casted in the vacuum resin casting machine imported from HEDRICH, Germany. The winding material ensures good permeability, no bubbles occur, which leads to minimum partial discharge. The HV and LV winding mate with each other tightly, which ensures solid strength of structure and capability to withstand short circuit and vibration. Under normal service condition, the service life of dry type transformer is 30 years. No crack will form on the surface of transformer winding due to temperature variation as long as the transformer runs under normal service condition.
11Kv Transformer,11Kv Dry Type Transformer,11Kv Cast-Resin Transformer,2500Kva Dry-Type Transformer
Hangzhou Qiantang River Electric Group Co., Ltd.(QRE) , https://www.qretransformer.com