Recently, Weibo users @汽车æ‹é˜¿ç¿ exposed a group of Geely new KC-2 interior spy photos. From the perspective of spy photos, the interior design style of the new car has changed a lot compared with the current model. Because it is built on the same platform as Borui, it is speculated that it may be Borui's mid-term redesigned model or a new replacement model. A few days ago, the domestic media exposed a suspected KC-2 internal information. According to the information, the new car will launch four models, the appearance and interior will be greatly changed, and is expected to carry the power combination of 1.5TGDI+7DCT.
In terms of appearance, the tail details can be seen from spy photos and are still in a tight camouflage stage. However, it can still be seen that Geely's new car has a slip-back design at the rear, which makes the side look more dynamic. In addition, the new car uses a new style of taillight design, the overall shape is slender and dynamic. In terms of body size, the new car has a length and height of 4956/1860/1516mm and a wheelbase of 2850mm.
In terms of interiors, the new car incorporates the latest design elements, and the sense of luxury is significantly improved. It can be seen that the new car center console adopts a new design style, equipped with a large-size LCD screen, and is also equipped with a three-spoke flat-bottom steering wheel, and the multi-function buttons on the steering wheel are also very rich. In addition, the new car is also equipped with a full LCD instrument panel, showing a wealth of information. In terms of configuration, the new car will be equipped with a one-button start, electronic handbrake, etc., as well as the latest multimedia entertainment system and upgraded active safety system.
In terms of power, the new car will be powered by a 1.5T engine with a maximum power of 132kW (179Ps) and a maximum torque of 265Nm. The drive is matched with a 7-speed DCT gearbox.
Small computer system interface (SCSI) is an independent processor standard for system level interfaces between computers and intelligent devices (hard disks, floppy drives, optical drives, printers, scanners, etc.). SCSI is an intelligent universal interface standard.
The last SCSI device in the SCSI chain uses a terminator, and the intermediate device does not need a terminator. Once the terminator is used by the intermediate device, the SCSI card cannot find the future SCSI device. If the last device does not use a terminator, SCSI will not work properly. Terminator is composed of resistors, located at the end of the SCSI bus, to reduce the mutual influence of the signal, maintain the constant voltage on the SCSI chain.
Most of the SCSI devices have built-in terminators and use a jumper to control on / off. The SCSI device is highly intelligent and can automatically control the terminator on / off. For example, if a hard disk is connected to a CD-ROM, the CD-ROM can work normally regardless of whether the terminator of the hard disk is on or off. However, when two hard disks are connected, the situation becomes more complicated. Before two Seagate hard disks are connected, one hard disk terminator must be off. Before a Seagate hard disk is connected to a quantum hard disk, a hard disk terminator can work normally regardless of whether it is on or off.
SCSI-90°DIP Section
ShenZhen Antenk Electronics Co,Ltd , https://www.antenkelec.com