Dual Tone MulTI-Frequency signaling is gradually used on push-button telephones worldwide. Because it provides higher dialing speed, it quickly replaces the dial pulse used by traditional rotary telephones. make. In recent years, DTMF has also been applied in interactive control, such as language menus, language mail, telephone banking, and ATM terminals. Integrating the generation and detection of DTMF signaling into any system containing a digital signal processor (DSP) is a valuable engineering application.
The DTMF codec converts keystrokes or digital information into a two-tone signal and transmits it during encoding, and detects the presence of keystrokes or digital information in the received DTMF signal during decoding. Each key on the telephone keypad is uniquely determined by the line and column frequencies shown in FIG. DTMF's codec solution does not require too much computation and can be easily executed concurrently with other tasks in the DSP system.
figure 1
As can be seen from Fig. 1, a DTMF signal is composed of a superposition of audio signals of two frequencies. The frequencies of the two audio signals come from two sets of pre-assigned frequency groups: a line frequency group or a column frequency group. Each pair of such audio signals uniquely represents a number or symbol. In order to generate the DTMF signal, the DSP uses software to generate two sine waves that are superimposed and transmitted. When decoding, the DSP uses the improved Goertzel algorithm to search for the existence of two sine waves from the frequency domain. This article discusses the implementation of DTMF codec on TI's fixed-point DSP chip TMS320C54x (hereafter referred to as C54x) series.
1, the generation of DTMF signals
The DTMF encoder is based on two second-order digital sine wave oscillators, one for generating the horizontal frequency and one for generating the column frequency. By loading the corresponding coefficients and initial conditions to the DSP, it is possible to generate the required eight audio signals using only two oscillators. The typical DTMF signal frequency range is 700 ~ 1700 Hz, and 8000 Hz is selected as the sampling frequency to meet the Nyquist condition.
figure 2
Submersible cable is a type of cable designed for use in underwater environments, such as in offshore oil and gas exploration, marine research, and underwater construction. These cables are typically made of materials that are resistant to corrosion, abrasion, and water damage, and are designed to withstand high pressures and temperatures.
Submersible cables are used to transmit power and data signals between underwater equipment and control systems on the surface. They may also be used to connect sensors and other monitoring devices to data acquisition systems.
The construction of submersible cables can vary depending on the application and the environment in which they will be used. Some cables may be armored with steel or other materials to provide additional protection against damage from rocks and other debris. Others may be coated with special materials to resist chemical corrosion or to improve their electrical conductivity.
Overall, submersible cables are essential components of many underwater applications, and their reliability and durability are critical to the success of these operations.
Submersible Electrical Pump Cable,Submersible Flat Cable,Flat Submersible Pump Cable,Waterproof Cable Rubber,Submersible Electrical Cable
Ruitian Cable CO.,LTD. , https://www.rtpowercable.com